English
EspaƱol
yt_link
insta_link
fb_link
twitter_link
ADVERTISERS
PCBWAY PCB Manufacturing

PCBWAY Christas PCB Manufacturing

Advanced PCB Manufacturing
Advanced PCB Manufacturing





AFFILATE










Gearbest Creality3D CR - 10S 3D Printer - EU Plug Upgrade Version Coffee and Black
Creality3D CR - 10S 3D Printer - EU Plug Upgrade Version Coffee and Black only $$352.94

Gearbest Creality 3D Ender-3 V-slot Prusa I3 DIY 3D Printer Kit 220 x 220 x 250mm Printing Size - EU Plug Black
Creality 3D Ender-3 V-slot Prusa I3 DIY 3D Printer Kit 220 x 220 x 250mm Printing Size - EU Plug Black only $$153.84

Gearbest Alfawise U20 Large Scale 2.8 inch Touch Screen DIY 3D Printer - EU - U20 EU Plug Black
Alfawise U20 Large Scale 2.8 inch Touch Screen DIY 3D Printer - EU - U20 EU Plug Black only $$253.39


I2C adress scanner


Download the .zip file below. Unzip it and open it in Arduino IDE. Compile and upload.






/// i2c_scanner
// This sketch tests the standard 7-bit addresses
// Devices with higher bit address might not be seen properly.
//
 
#include <Wire.h>
 
 
void setup()
{
  Wire.begin();
 
  Serial.begin(9600);
  while (!Serial);             // Leonardo: wait for serial monitor
  Serial.println("\nI2C Scanner");
}
 
 
void loop()
{
  byte error, address;
  int nDevices;
 
  Serial.println("Scanning...");
 
  nDevices = 0;
  for(address = 1; address < 127; address++ )
  {
    // The i2c_scanner uses the return value of
    // the Write.endTransmisstion to see if
    // a device did acknowledge to the address.
    Wire.beginTransmission(address);
    error = Wire.endTransmission();
 
    if (error == 0)
    {
      Serial.print("I2C device found at address 0x");
      if (address<16)
        Serial.print("0");
      Serial.print(address,HEX);
      Serial.println("  !");
 
      nDevices++;
    }
    else if (error==4)
    {
      Serial.print("Unknown error at address 0x");
      if (address<16)
        Serial.print("0");
      Serial.println(address,HEX);
    }    
  }
  if (nDevices == 0)
    Serial.println("No I2C devices found\n");
  else
    Serial.println("done\n");
 
  delay(5000);           // wait 5 seconds for next scan
}