Incase testing the transmiter,my throttle pitch etc values does not change and remain as such..when i upload the test code to arduino uno,and connect the wires written in the test code to nrf;and set the baud rate to 250000
->>my values appear like this
(throttle 0,yaw 0,pitch 127,roll 127,aux1 0,aux2 0,) from start and continue to remain as such until turned off.
I saw in your video,this started with some values other than 0 and 127... Like 55,etc
Is this a thing to worry or is it working fine;and if not what may be the possible cause s