35 Online
2 Member And 33 Guest
Members present at the site
Today Visits : 1461
Yesterday Visits : 20681
All Visits : 2786007

Welcome to Electronoobs Q&A, where you can ask questions and receive answers from other members of the community.


0 like 0 dislike

Thanks in advance...

Initially we used atmega328p-PU for development board in our project. Due to space concerns we have tried implementing the same with SMD chip which is atmega328P-AU.

Since it does not have bootloader by default, we followed instructions as mentioned in the link : Burn bootloader ATmega328-AU SMD

Bootloader got burnt successfully and firmware also uploaded. Blink was working fine(with interval of 100ms we tested).

But while we upload our project firmware in the same chip not working consistently. Serial monitor is not printing the values we expected at times.

Could someone help us on this???

in Arduino by (120 points)

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register.